[glux] add ons Lilo
gigi-eliotisc
eliotec@tiscalinet.it
Fri, 27 Sep 2002 17:09:15 +0200
dopo la istruttiva chiaccherata su Lilo
sono riuscito a farmi un dischetto di avvio di emergenza
sto trasferendo il so del serverino da un disco ad un'altro
ora quando cerco di far partire la macchina dal nuovo disco( naturalmente col dischetto)
LILO mi si blocca a LIL
ho trovato queste spegazioni ma non ho capito come risolvere il problema
When LILO loads itself, it displays the word
LILO. Each letter is printed before or after performing
some specific action. If LILO fails at some point, the letters printed so
far can be used to identify the problem.
Output
Problem
(nothing)
No part of LILO has been loaded. LILO either isn't installed or
the partition on which its boot sector is located isn't active.
L
The first stage boot loader has been loaded and started, but it
can't load the second stage boot loader. The two-digit error
codes indicate the type of problem. (See also section ``Disk error
codes''.) This condition usually indicates a media failure or a
geometry mismatch (e.g. bad disk parameters).
LI
The first stage boot loader was able to load the second stage boot
loader, but has failed to execute it. This can either be caused by
a geometry mismatch or by moving /boot/boot.b
without running the map installer.
LIL
The second stage boot loader has been started, but it can't load
the descriptor table from the map file. This is typically caused
by a media failure or by a geometry mismatch.
LIL?
The second stage boot loader has been loaded at an incorrect
address. This is typically caused by a subtle geometry mismatch or
by moving /boot/boot.b without running the
map installer.
LIL-
The descriptor table is corrupt. This can either be caused by a
geometry mismatch or by moving /boot/map without running the map
installer.
LILO
All parts of LILO have been successfully loaded.
che e' sta descriptor table e il map file??
ciao
gigi