[hack] lan a 3
thomas
thomas@viaoberdan.it
Dom 28 Gen 2007 01:25:30 CET
Alle 22:57, sabato 27 gennaio 2007, A&P abbiamo ricevuto:
> infatti e' proprio li' il problema: se noti, non c'e' nessun indirizzo
> configurato su eth1 (seconda scheda di rete) e di conseguenza non hai
> routing su di essa...
Hai ragione ho fatto ifconfig e route dopo aver disattivato eth1. Ma
riattivandola il risultato non cambia:
eth0 Link encap:Ethernet HWaddr 00:30:84:0A:A9:09
inet addr:192.168.0.1 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::230:84ff:fe0a:a909/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:193 errors:0 dropped:0 overruns:0 frame:0
TX packets:60 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:11580 (11.3 KiB) TX bytes:9617 (9.3 KiB)
Interrupt:169 Base address:0xec00
eth1 Link encap:Ethernet HWaddr 00:05:5D:44:F5:C4
inet addr:192.168.2.1 Bcast:192.168.2.255 Mask:255.255.255.0
inet6 addr: fe80::205:5dff:fe44:f5c4/64 Scope:Link
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:58 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:9506 (9.2 KiB)
Interrupt:177 Base address:0xe800
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:188 errors:0 dropped:0 overruns:0 frame:0
TX packets:188 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:12312 (12.0 KiB) TX bytes:12312 (12.0 KiB)
ppp0 Link encap:Point-to-Point Protocol
inet addr:82.57.142.5 P-t-P:192.168.100.1 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:9178 Metric:1
RX packets:8276 errors:0 dropped:0 overruns:0 frame:0
TX packets:7952 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:4495321 (4.2 MiB) TX bytes:1111148 (1.0 MiB)
e route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.100.1 * 255.255.255.255 UH 0 0 0 ppp0
192.168.2.0 * 255.255.255.0 U 0 0 0 eth1
localnet * 255.255.255.0 U 0 0 0 eth0
default 192.168.100.1 0.0.0.0 UG 0 0 0 ppp0
Ma la condivisione della adsl non avviene. Il server non ha problemi, il mac
non condivide (e neanche il pc2 se è attiva eth1).
Sai che penso? Che il problema sia qui:
modem_run -k -f /usr/share/doc/speedtouch/mgmt.o && pppd call adsl
iptables -t nat -A POSTROUTING -o ppp0 -j MASQUERADE
echo 1 > /proc/sys/net/ipv4/ip_forward
iptables -A INPUT -m state --state ESTABLISHED,RELATED -j ACCEPT
iptables -A INPUT -m state --state NEW -i ! ppp0 -j ACCEPT
iptables -P INPUT DROP
#iptables -P INPUT ACCEPT
Ma dove?
Ciao
Thomas
Maggiori informazioni sulla lista
golem-hack