[Primipassi] Re: kismet

[S. B.]

Silvio Relli wrote:
> 
> 
> Simone wrote:
> 
>>>Ciao, guarda ti incollo sotto l' errore : ti premetto che al
>>>comando iwconfig eth1 mode monitor non da errori mentre se gli do
>>>iwconfig: eth1      IEEE 802.11-DS  ESSID:"" Mode:Managed
>>>Frequency:2.442 GHz  Access Point: FF:FF:FF:FF:FF:FF Bit Rate:11
>>>Mb/s   Tx-Power=0 dBm   Sensitivity=0/65535 Retry limit:16   RTS
>>>thr:off   Fragment thr:off Encryption key:off Power Management:off
>>>Link Quality=32/10  Signal level=-106 dBm  Noise level=-106 dBm Rx
>>>invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0 Tx excessive
>>>retries:0  Invalid misc:7   Missed beacon:0
>>>
>>>wifi0     IEEE 802.11-DS  ESSID:"" Mode:Managed  Frequency:2.442
>>>GHz  Access Point: FF:FF:FF:FF:FF:FF Bit Rate:11 Mb/s   Tx-Power=0
>>>dBm   Sensitivity=0/65535 Retry limit:16   RTS thr:off   Fragment
>>>thr:off Encryption key:off Power Management:off Link Quality=32/10
>>>Signal level=-106 dBm  Noise level=-106 dBm Rx invalid nwid:0  Rx
>>>invalid crypt:0  Rx invalid frag:0 Tx excessive retries:0  Invalid
>>>misc:7   Missed beacon:0
>>>
>>>alkatraz:/home/blackcrow#
>>>
>>>------------------------------- alkatraz:/home/blackcrow# kismet
>>>Server options:  none Client options:  none Starting server... Suid
>>>priv-dropping disabled.  This may not be secure. No specific
>>>sources given to be enabled, all will be enabled. Enabling channel
>>>hopping. Enabling channel splitting. Source 0 (ciscosource):
>>>Enabling monitor mode for cisco source interface eth1 channel 6...
>>>Waiting for server to start before starting UI... Source 0
>>>(ciscosource): Opening cisco source interface eth1... FATAL: pcap
>>>reported netlink type 1 (EN10MB) for eth1.  This probably means
>>>you're not in RFMON mode or your drivers are reporting a bad value.
>>>Make sure you have the correct drivers and that entering monitor
>>>mode succeeded. alkatraz:/home/blackcrow#
>>>----------------------------- in kismet ho messo:
>>>source=Cisco,eth1,ciscosource
>>>
>>>-- pub 1024D/EBFFEE94 Key fingerprint = 9E78 B50F AC6B 6911 08D7
>>>76BE 0DED 6BE1 EBFF EE94
>>>---------------------------------------------------------------------------
>>>
>>>
>>>"Chi è pronto a rinunciare alle proprie libertà fondamentali per
>>>comprarsi briciole di temporanea sicurezza non merita nè la libertà
>>>nè la sicurezza" - Benjamin Franklin
>>>
>>>
> 
> 
> 
> vedrai è colpa del driver
> prova a usare come driver di kismet cisco_wifix invece che cisco.
> infatti cisco va bene x i kernel fino al 2.4.19
> cisco_wifix invece è per le vers successive del kernel
> o almeno così dicono nella documentazione ;-)
> non ho mai messo le mani su un aironet!
> 
> fammi sapere se ti va!
grande funziona :-)

ho messo
source=cisco_wifix,eth1:wifi0,ciscosource

funziona :-)

grazieeeeee