EDO SODIMM

David Jones goofy_36@yahoo.com
Thu Apr 1 17:13:34 CEST 2004


Good question about the speed.  If I remember
correctly, high speed ATA IDE interface/cable runs at
133mhz and it's good for 18 inches ( about 1/2 meter
).  So if we keep the cable short and doesn't run over
anything noisy, it should be ok.  If it doesn't work,
we could always try something else.

--- Oleg Gusev <oleg@usm.uni-muenchen.de> wrote:
> 
> >We can probably put our memory upgrade
> >where the HP one would normally go and use some
> ribbon
> >cable for the connections.
> 
> What frequency we are talking here about ? It's not
> even
> SDRAM! I'm curious if the the piece of a good IDE
> cable
> will be ok :) Hmm. 32 (D0-31) + 27 (A0-26) + 2/2
> (CAS) +
> 2 (RAS) + 1 (OE) + 1 (WR) = 67 pins of 70=2x35
> connector.
> Sounds reasonable. The pictures of Francois give a
> lot
> of hope, but still not 100%...
> 
>  Oleg.


__________________________________
Do you Yahoo!?
Yahoo! Small Business $15K Web Design Giveaway 
http://promotions.yahoo.com/design_giveaway/


More information about the Jornada820 mailing list